Configuring Router-On-A-Stick Inter-Vlan Routing Packet Tracer. Ping between pc1 and pc3. Create vlans and assign switch ports part 3:
S1 and r1 already have basic configurations. Ping between pc1 and pc3. Configure trunk connection between router and a switch 4.
Switching, Routing, And Wireless Essentials4.2.7 Packet Tracer.
Ping between pc1 and pc3. Refer to the address table. Router on stick configuration steps
Build The Network And Configure Basic Device Settings Part 2:
Configure an 802.1q trunk between the switches part 4: Configure trunk connection between router and a switch 4. Finally, you will enable trunking and verify connectivity between vlans.
Web Router On A Stick Configuration In Packet Tracer.
Web cisco hands on course router on stick topology router on stick (inter vlan routing) topology basically consist of one switch and a router. First of all, create two vlan in the switch and named vlan a and vlan b with the following command. Here, the switch is the place that our vlans exist and the router is the device that route the traffic.
Because The Two Pcs Are On Separate Networks And R1 Is Not.
Assign ip address and default gateway to the pc 2. Switch>enable switch#configure terminal enter configuration commands, one per line. Watch, learn, subscribe and share!
Configure Subinterfaces On R1 Using The 802.1Q Encapsulation.
Switch to simulation mode to monitor pings. Ping between pc1 and pc3. This is part of the switching, routing, and wireless essentials version 7 cisco networking.