Focusrite Scarlett Solo Output Routing. Web 00:00 what is focusrite control? These are selected by the tabs at the top of the window.
This tab will show you your interface’s outputs and what is routed to them. The outputs for the interface are listed as well as the source for each output. Web i’ve checked firmware and focusrite control versions, run diagnostics on the laptop, had the i/f connected both direct to the laptop and via the dock it’s normally on, and everything checks out, but the scarlett does the same trick in all configurations.
The Output Routing Page Is Divided Into Three Areas:
Although all inputs and outputs on the. Web your os should automatically switch the computer’s default audio inputs and outputs to the scarlett solo. Similarly, the daw’s monitor or recorded output will appear at the unit’s physical outputs.
Under The Output Routing Section, Choose An Output To Use.
Maximum output power 32mw into 33ω 22mw into 300ω; Web applies to scarlett 4th gen. Web i did configure windows to accept scarlett as the input and output through the speakers, but when i open ableton live i get no sound from the speakers, and the audio menu only shows the option to output through.
Web The Output Routing Window Is Where You Assign Your Inputs And Outputs To Different Sources.
Web for more information on focusrite control ios: Dynamic range 112db @ 33ω 115db @ 300ω; To verify this, go to system preferences > sound, and ensure that the input and output are set to scarlett solo.
It’s Comprised Of Three Separate Sections — Hardware Inputs, Software (Daw) Playback, And Outputs.
Open comment sort options tomfocusrite • 3 yr. The output routing page is very similar across our interface ranges and can be found in the relevant user guides. This just started happening to my 10+ year old scarlett solo last week.
Web Recorded In The Daw And Then Routed From Your Daw To The Physical Outputs.
This means that the audio output will have very low noise and a high level of clarity, allowing for accurate monitoring while recording or listening back to audio. The scarlett solo’s various physical outputs can be connected to the hp60 headphones, or if you wish, to an amplifier and speakers, powered monitors, analogue mixer or any other analogue audio equipment that you wish to use. On the scarlett solo and 2i2 3rd gen the output routing section in focusrite control doesn’t have any function.